Establishing a Wi-Fi extender is not a difficult process. If you follow the proper procedure, you can finish the installation of your Netgear WiFi extender setup in just a few minutes and have your house or office covered with a wider and stronger network.
If the internet is slow due to dead zones and faint signals, a Netgear extender will get a boost for your existing Wi-Fi, leading to the whole house having internet without interruptions.
Plug in your extender
Install the extender at a point between your router and the weak-signal area. Make it ready and watch the light getting stable.
Connect to the extender network
Take the Wi-Fi settings of your phone or laptop and join the "Netgear_EXT" network.
Go to the mywifiext net
Open a web browser and type in the mywifiext net URL in the address bar. The Netgear settings page will be opened.
Obey on-screen directions
Set up a username and password for admin, choose your home Wi-Fi, and provide the password for linking the two.
Place the extender
Once the setup is complete, move it to a place where there is a good signal from the router. The green light means that the connection was successful.
An updated extender always has better working performance and connection issue less.
Access mywifiext.net → Settings → Firmware Update, check for and install the most recent update.
With the right placement and simple Netgear WiFi Extender Setup, you can get rid of dead Wi-Fi zones in a few minutes. Also, don’t forget to perform update firmware on Netgear Extender regularly to get the most out of it.